ASSEMBLE TRANSMISSION (cont) - TM-5-3805-260-24

ASSEMBLE TRANSMISSION (cont) - TM-5-3805-260-24_436

TM-5-3805-260-24 Scraper Tractor: Elevating Self-Propelled 11 Cubic Yard Sectionalized and Nonsectionalized Manual
Page Navigation
406

TM 5-3805-260-24 TRANSMISSION 42. Install pin (78), seal rings (77) and coupling (75) in shaft assembly (76). Install the ring that holds coupling (75) in shaft assembly (76). 43. Install the seal ring on coupling (75). 44.Install shaft assembly (76). 45. Assemble No. 2 planetary carrier as follows: a) Install the seal ring on carrier assembly (79). b) Install bearings (80) and (82) in each gear (81). c) Put gears (8 1) in position in carrier assembly (79) with washers (85) on each side of the gears. d) Install shaft (83) in carrier assembly (79) to hold gears (81) and washers (85) in position. Make sure the holes in the shafts are in alignment with the holes in the carrier assembly . e) Install pins (84) even with the surface of carrier assembly (79) to hold shafts (83) in position. 46. Lower the temperature of bearing (87) and install it in plate (89). Make sure the notch in bearing (87) is down when it is installed in the plate. Install ring (86) to hold the bearing. 47. Heat sleeve (88) in oil to a maximum temperature of 275°F (I 35°C) and install it on carrier assembly (79).Install the dowel in carrier assembly (79) above sleeve (88). Install the seal ring on sleeve (88). 48. Put plate (89) on carrier assembly (79). Make sure the notch in bearing (87) engages with the dowel in carrier assembly (79). Install the ring that holds plate (89) and carrier assembly (79) together. 49. Install plate (89) on the No. 2 clutch housing. 3-210

Privacy Statement
Press Release
Contact