TM 5-3805-260-24TRANSMISSION57.Install ring (105) to hold the No. 1 clutch inposition.58.Install the O-ring seals on sleeve (106).59.Install sleeve (106) and ring (107) so the sleeveis pushed all the way into the output transfer gearcase for installation of the valve manifold.60.Make sure the five O-ring seals (108) are inposition on the transmission.61.Install manifold (109) and tighten the four bolts(110) to a torque of 35 + 3 Ib. ft. (45 + 4 N. m).62.Push sleeve (106) up into manifold (109) andinstall ring (107) to hold the sleeve in position.NOTE: See ASSEMBLE TRANSMISSION HYDRAULICCONTROL VALVES to assemble the selector andpressure control valves.CAUTION: When selector valve (11) is installed thevalve spools must be held in position because they arefree to fall out and be damaged.63.Put selector valve (111) in position and installthree 5/16"-18 NC guide bolts (112)approximately 7 in. (17.8 cm) long to hold thevalve.64.Put levers (115) in position. Make sure that thelevers are engaged with the valve spools andpush shafts (113) and (1 14) into levers (115).Install the bolts that hold the levers to the shaftsand tighten them to a torque of 35 + 3 lb. ft. (45+ 4 N. m).3-213
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business