TM 5-3805-260-24
TRANSMISSION HYDRAULIC CONTROL VALVES
ASSEMBLE TRANSMISSION HYDRAULIC
CONTROL VALVES
1.
Assemble the selector valve as follows:
a)
Make sure all of the parts of the selector
control valve are clean and free of dirt. Put
clean SAE 30 oil on the parts of the selector
valve.
b)
Install the plunger, spring, washer and ring
in relief valve assembly (2).
c)
Install relief valve assembly (2) in the valve
body. Install the cover and tighten the bolts
to a torque of 22 + 3 lb. ft. (30 + 4 N. m).
d)
Install speed selector valve spool assembly
(1) in the valve body.
e)
Install directional valve spool (3).
f)
Make a replacement of the O-ring seals on
detent assemblies (5) if necessary. Install
the detent assemblies (4).
g)
Install the setscrew and lock in hole (5).
h)
Install speed selector valve spool (6).
j)
Make a replacement of the O-ring seals on
detent assemblies (7) if necessary and
install the detent assemblies.
k)
Install stop (9), the two washers and bolt
(8).
3-217
