TM 5-3805-260-24BOWL AND EJECTOR CONTROL VALVEDISASSEMBLE BOWL AND EJECTORCONTROL VALVETools NeededAB1P1857Snap Ring Pliers11P1856Snap Ring Pliers1start by:a)remove bowl and ejector control valve.1.Remove four screws (1), retainers (3), rubber seals (2) and the washers from the valve spools.2.Remove four bolts (4). Remove caps (5) and (6) from the body. Remove cap (6) carefully because of the three balls on the valve spool.3.Remove the O-ring seal from the front of cap (5). Remove plug assembly (7), the spring and the ring from cap (5).4.Remove sliding door cylinder valve spool (8) and bowl lift spool (9) from the body. Remove sleeve (10) from spool (8). Remove the two O-ring seals from inside the body. Check the condition of the seals. If the seals have damage, use new parts for replacement.5.Remove snap ring (12) with tool (A). Remove the washer, the spring and the plunger from in- side valve spool (8). Turn retainer (i 1) off valve spool (8). Remove the piston assembly, the spring and the two washers from the spool.4-84
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business