TM 5-3805-260-24BOWL AND EJECTOR CONTROL VALVE12.Install sleeve (36) on valve spool (23). Install the valve spool in the body.13.Install O-ring seal (41) in cap (37). Put the seals on valve spool (38) and plug (40). Install valve spool (38), spring (39) and plug (40) in cap (37).NOTE: Put 4L7464 Silicone Grease on the ends of thevalve spools before the installation of the caps.14.Install cap (37) and two bolts (42). Install the seal in cap (44) and three balls (43) on the valve spool. Install cap (44) on the valve spool and install two bolts to hold it. Tighten the four bolts to a torque of 10 to 13 lb. ft. (14 to 18 N. m).NOTE: Put 4L7464 Silicone Grease on the ends of thevalve spools before the installation of the rubber seals.15.Install washers (45), retainers-(47) and rubber seals (46) on the valve spools. Install the four screws that hold the retainers.end by:a)install bowl and ejector control valve4-89
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
