TM 5-3805-260-24
SLIDING FLOOR LINK, SLIDING FLOOR ARM ASSEMBLY
2.
Install bolt and nut (3) in both ends of the link.
Remove wood blocks from the front of the
scraper.
REMOVE SLIDING FLOOR ARM ASSEMBLY
Tools Needed
A
1P510
Driver Group
1
start by:
a)
remove ejector cylinder
1. Make preparations to remove sliding floor arm
assembly
a)
Lift the bowl and put supports under routing
bits.
b)
Put a floor jack under the cutting edge.
c)
Put a wood block under the links.
2. Remove bolts (2) from links (3) where they connect to the arm
(1).
3. Remove tube (4) from both links (3) with tooling (A).
4. Remove bolts (7) and washer (6) from cylinder retaining pin
which is installed in arm assembly (5).
4-179
