TM 5-3805-260-24
SLIDING FLOOR CYLINDER
REMOVE SLIDING FLOOR
CYLINDER
Tools Needed
A
1 P510
Driver Group
1
WARNING: Make sure all of the
hydraulic pressure is released from
the hydraulic system before any
lines are disconnected.
1.
Make preparations to remove sliding floor
cylinders.
a)
Lift the bowl and place wood blocks under
routing bits.
b)
Move the sliding floor to one-fourth open
position and install floor jack under cutting
edge.
2.
To remove the rear cover assembly, see
REMOVE EJECTOR CYLINDER for details.
3.
Remove top portion of clamp (1) from sliding
floor cylinder (2).
4.
Remove bolts (3) from the tube assembly.
5.
At the rod end of the cylinder, remove bolts (5)
and plate (4) from the arm.
6.
On other side of arm, remove bolts (7) and
washer (6) from the arm.
7
4-183
