TM 5-2350-377-13&P
0035
REMOVAL
NOTE
Use this task to replace left or right support. Right support is shown.
1.
Remove jam nut (Figure 1, Item 9) from receptacle connector (Figure 1, Item 2) and support
(Figure 1, Item 8).
2.
Remove three screws (Figure 1, Item 5), lockwashers (Figure 1, Item 6) and washers (Figure 1, Item 7) from
support (Figure 1, Item 8) and headlight body (Figure 1, Item 1). Discard lockwashers.
3.
Gently take support (Figure 1, Item 8) off body (Figure 1, Item 1) while pushing connector (Figure 1, Item 2)
through hole (Figure 1, Item 4) in support (Figure 1, Item 8).
4.
Remove gasket (Figure 1, Item 3) from support (Figure 1, Item 8) and body (Figure 1, Item 1). Discard gasket.
WARNING
Cleaning solvent is combustible. Wear protective goggles and gloves; use only in a well-
ventilated area; avoid contact with skin, eyes, and clothes; and do not breathe vapors.
Keep away from heat or flame. Never smoke when using cleaning solvent; the flashpoint
is 144F (62C). Failure to follow this warning may result in injury or death to personnel.
A fire extinguisher will be kept nearby when the solvent is used.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush them with water and get immediate medical attention.
When cleaning solvent is used, notify the local medical authority (preventive medicine)
and environmental coordinator concerning medical surveillance, respiratory protection,
and disposal requirements.
5.
Clean off any gasket material from body (Figure 1, Item 1) with solvent, wire brush, and rag.
4
3
1
2
5
6
7
8
9
M0017HBF
Figure 1. Headlight Support Removal.
END OF TASK
03/15/2011Rel(1.8)root(maintwp)wpno(M00008)