TM 5-2350-377-13&P
0043
INSTALLATION - Continued
NOTE
There is an additional clamp on left hydraulic track adjusting cylinder.
Coat threads of screw and nut with lubricating oil prior to installation.
4.
Connect rod end (Figure 6, Item 2) of hydraulic track adjusting cylinder (Figure 6, Item 1) to final drive adjusting
flange (Figure 6, Item 7) with pin (Figure 6, Item 5), washer (Figure 6, Item 4), screw (Figure 6, Item 6), washer
(Figure 6, Item 4), and new locknut (Figure 6, Item 3).
5
4
4
3
2
6
1
7
M0078HBF
Figure 6. Final Drive Adjusting Flange Installation.
5.
Tighten locknuts (Figure 7, Item 2) to 19 to 31 lb-ft (25.8 to 42 Nm).
6.
Lubricate bearings (Figure 7, Item 4) with Grease, Automotive and Arillery (GAA) at lubrication fittings
(Figure 7, Items 1 and 3).
3
2
4
1
2
4
M0079HBF
Figure 7. Track Adjusting Cylinder Locknuts Installation.
03/15/2011Rel(1.8)root(maintwp)wpno(M00015)