TM 5-3800-205-23-1
CRANKSHAFT REAR SEAL CARRIER REPLACEMENT - CONTINUED
0128 00
INSTALLATION
1.
Install new gasket (5) on seal carrier (3).
CAUTION
Use care not to allow sealant to get into oil passage in mounting face of cylinder block.
2.
Clean mounting surfaces of rear seal carrier (3), crank-
shaft (6) and cylinder block (4).
4
5
3
6
3.
Apply primer and sealant to face of rear seal. Spread
sealant uniformly. Allow primer to dry for three to five
minutes.
CAUTION
Rear seal carrier must be installed within 10 minutes of application of sealant.
4.
Position rear seal carrier (3) on dowel pins in rear of cylinder block (4). If necessary, use a soft-faced hammer to position
rear seal carrier against cylinder block.
5.
Apply adhesive to threads of eight bolts (1). Install
washers (2) and bolts (1) to secure rear seal carrier (3).
1,2
4
3
6.
Install new gasket and engine oil pan (WP 0014 00).
7.
Install flywheel housing (WP 0130 00).
END OF WORK PACKAGE
0128 00-2
