TM 5-3800-205-23-2
ELEVATOR GUARD REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Maintenance Level
Personnel Required
Two
Unit
Equipment Condition
Tools and Special Tools
Machine parked on hard, level surface (TM 5-3800-
205-10-1)
Tool kit, general mechanic's (Item 33, WP 0048 00)
Scraper bowl lowered to ground (TM 5-3800-205-
Sling, nylon (Item 27, WP 0048 00)
10-1)
Parking brake applied (TM 5-3800-205-10-1)
Materials/Parts
Wheels chocked (TM 5-3800-205-10-1)
Seal, lip
Battery disconnect switch in OFF position (TM 5-
3800-205-10-1)
Grease, GAA (Item 16, WP 0047 00)
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proc-
dure. Ensure that any lifting device used is in good condition and of suitable lift capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in injury or death to
personnel.
REMOVAL
1.
Attach nylon slings and suitable lifting device to elevator guard (1). Take up slack in nylon slings.
2.
On left side of machine, remove five bolts (2) and washers (3) from separate elevator guard (1) and speed reducer (4).
1
1
2,3
4
390-1809
