TM 5-3805-248-23-2
GOVERNOR ASSEMBLY REPAIR - CONTINUED
0354 00
ASSEMBLY - CONTINUED
31.
Install new gasket (30) on rear of fuel injection
29
pump (3).
32.
Position governor assembly (8) on fuel injection pump
30
(3).
31
33.
Install two bolts (33), bolt (31), two bolts (32) and bolt
(29) on governor assembly housing (8).
33
8
32
3
394-1217
34.
Install setscrew (28) flush with inside face of collar (21).
35.
Install nut (26) on setscrew (28). Do not tighten nut (26) at this time.
36.
Install setscrew (22) in collar (21). Rotate clockwise two turns.
37.
Install spring (27) and collar assembly (21) on load stop bolt (45).
NOTE
For proper location, collar must be pushed in to compress spring.
38.
Push collar (21) in and hold.
26
21
39.
Tighten setscrew (22).
40.
Rotate setscrew (28) clockwise until screw bottoms
22
27
against surface of governor assembly housing (8).
28
41.
Torque nut (26) on setscrew (28) to 9 lb-ft (12 Nm).
394-1216
0354 00-9
