TM 5-3805-248-23-2
GOVERNOR ASSEMBLY REPAIR - CONTINUED
0354 00
FUEL SETTING PROCEDURE - CONTINUED
94
COMPRESSOR ASSEMBLY
97
394-1713
98
394-1712
11.
Turn rod (97) in compressor assembly until knob is approximately 1 in. (25.4 mm) away from compressor body.
CAUTION
DO NOT turn the rod any further in if the rod begins to tighten. Damage to the governor can occur if the rod
is turned in further.
NOTE
The compressor assembly is used to compress the overfueling spring through the linkage. The overfueling
spring must be compressed to get an accurate fuel setting measurement.
12.
Install compressor assembly (98) in adapter (94).
0354 00-14
