TM 5-3805-260-24
ENGINE REAR SUPPORTS
SUPPORTS
Tools Needed
A
8S7630
Stand
1
8S7611
Tube
1
8S7615
Pin
2
8S7625
Collar
1
8S7650
Cylinder
1
5P3100
Pump Group
1
start by:
a) remove crankcase guard
WARNING: Remove and install only one sup-
port at a time so the engine will not move off of
tooling (A).
1. Put tooling (A) in position under the torque con-
verter.
2. Remove the four bolts (2) and the washer to
remove panel assembly (1) from the machine.
3. Remove the left rear engine support as follows:
a) Remove bolt (4) and the nut from the left rear
support. Remote bracket (3) from the
machine.
b) Remove the upper half of the mount assem-
bly (5) from the support assembly.
c) Use tooling (A) to lift the engine enough to
take the weight off of support assembly (6).
Remove bolts (7), the washers, support as-
sembly (6) and the lower half of the mount
assembly.
3-126
