TM 5-3805-260-24
ENGINE
REMOVE ENGINE
Tools Needed
A
8S7620
Base Assembly
1
BS7650
Cylinder
1
8S7615
Pin
1
5P3100
Pump Group
1
start by:
a)
remove radiator
b)
remove oil pan
1.
Tilt the cab as follows:
a)
Disconnect steering linkage (2) from
steering control valve (1).
b)
Remove the four bolts and nuts that hold
left rear fender (3) to the cab.
c)
Remove the panel assembly that is the
support for the rear of the hood.
d)
Remove pin (4) that holds the jack
assembly to the cab.
e)
Remove the pin that holds jack assembly
(5) to the storage bracket and put the jack
assembly in position on the tractor frame.
Install the storage pin through the jack
assembly and hole (7) in the frame.
f)
Put the top portion of the jack assembly in
position on the cab and install the pin to
hold it.
g)
Remove bolt (6), the nut and the storage
bracket.
h)
Remove the bolt and nut that holds the
right front corner of the cab to the frame.
j)
Tilt the cab with jack assembly (5).
2.
Remove the oil level gauge from the engine.
3.
Remove plug (8) and drain the oil from the
torque converter. The torque converter capacity
is 6.5 U.S. gal. (24.6 litre).
3-131
