TM 5-3805-260-24
ENGINE REAR SUPPORTS
4. Remove the engine support for the right rear as
follows:
a) Remove bolt (9) and the nut from the support
b) Remove the upper half of mount assembly
c) Use tooling (A) to lift the engine enough to
take the weight off of support assembly (11).
Remove bolts (10), the washers, support as-
sembly (11) and the lower half of the mount
assembly.
INSTALL ENGINE REAR
SUPPORTS
Tools Needed
A
8S7630
Stand
1
8S7611
Tube
1
8S7615
Pin
2
8S7625
Collar
1
8S7650
Cylinder
1
5P3100
Pump Group
1
1. Install the right rear engine support as follows:
a) Put the lower half of the mount assembly in
position on the tractor frame.
b) Put support assembly (2) in position and in-
stall bolts (3) and the washers to hold it to the
flywheel housing. Make sure ground cable
(1) is in position before the bolts are tight-end
c) Put the upper half of the mount assembly in
position and install bolt (4) and the nut.
d) Lower the engine with tooling (A) and
tighten bolt (4).
3-127
