TM 5-3805-260-24OUTPUT TRANSFER GEARS27.Heat bearing cone (31) in oil to a maximumtemperature of 275°F (135°C). Install bearing cone(31) on input gear (30).28.Heat bearing cone (32) in oil to a maximumtemperature of 275°F (135°C). Install bearing cone(32) on input gear (30).29.Install ring (33) on input gear (30). Install input gear(30) in the transfer gears case.30.Heat seal carrier (34) in oil to a maximumtemperature of 275°F (135°C) for no more than 10minutes. Make sure the part number on carrier (34)can be seen and the hole in the carrier is inalignment with the hole in the cage assembly andinstall the carrier on cage assembly (35). Installspring pin (36) in the cage assembly.31.Install the seal rings on carrier (34).32.Lower the temperature of bearing cup (37) and installit in cage assembly (35).33.Install cage assembly (35) in the output transfergears case. Install the locks and bolts that hold thecage assembly in position.34.Use tool group (B) and check the input gear end play.The end play must be .003 to .005 in. (0.08 to 0. 13mm). If the end play is not correct, add or subtractshims from under the rear bearing cage to get thecorrect amount of end play.end by:a)assemble transmission3-227
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business