TM 5-3805-260-24
TRANSMISSION CONTROL LINKAGE,
HYDRAULIC VALVE CONTROL LEVERS
2.
Install the plate and handle (2) to the rod. Install the pin
in the handle. Install the rod assembly, spring and
spacer in the console. Install the three bolts to the plate.
3.
Put cable (7) through lever (4) and install nut (6). Put
lever (4) in position over the rod end and install pin (5)
through the lever and the rod end. Install the nut on the
back of pin (5).
4.
Turn the shift lever in lever (4) and tighten
locknut (3).
5.
Install transmission cable (8) to the pin.
REMOVE HYDRAULIC VALVE
CONTROL LEVERS
Tools Needed
A
1P510
Driver Group
1
1.
Remove clip (I) and pin (2) from jack (4). Pull the jack
free of the cab so shaft (3) can be re- moved.
2.
To remove the knobs, the cover assemble and the links
from inside the cab, see REMOVE CAB, Steps 8 and 9
for details.
3.
Loosen setscrew (5) on shaft (3).
3-334
