TM 5-3805-260-24
HYDRAULIC VALVE CONTROL LEVERS
3.
Put lever (6) in position as shown and install bolt (3) to the
bracket. Install cable (4) in the cab.
4.
Install ball (5), the spring and the setscrew in the bracket.
Move lever (6) up so the ball is in a notch in the lever.
Tighten the setscrew until the correct tension is on the
spring.
5.
Install shaft (7) in the cab.
6.
Install the spring, the two washers, the link, the three
levers, the two washers and the lever (10) as the shaft is
installed.
7.
Tighten setscrew (8) in hole (9) in the shaft. Put the
levers in position as shown.
8.
To install the links, the cover assembly, the knobs and
correct procedure for all adjustments, see INSTALL CAB
Steps 16 and 17 for details.
9.
Put jack (11) in position and install the pin and the clip.
3-336
