HYDRAULIC VALVE CONTROL LEVERS

TM-5-3805-260-24 Scraper Tractor: Elevating Self-Propelled 11 Cubic Yard Sectionalized and Nonsectionalized Manual
Page Navigation
529

TM 5-3805-260-24 HYDRAULIC VALVE CONTROL LEVERS 4. Use a short punch and remove shaft (3) from the opening outside the cab. As the shaft is removed the levers, washers, link and spring will fall in the compartment. NOTE: Put a plug in hole in the bottom of the compartment to prevent the loss of any parts. 5. Keep lever (7) in the position as shown until the setscrew on the back side of bracket (4) is loosened. This will release spring tension on a small ball directly behind lever (7). After the lever moves freely lower it and remove the ball, the spring and the setscrew. 6. Remove bolt (5) and cable (6) so lever (7) can be removed. 7. Remove bushings (8) from control lever (10) with tooling (A). Remove dowels (9) from the control lever. NOTE: The dowels on the rear control lever only are different lengths. INSTALL HYDRAULIC VALVE CONTROL LEVERS Tools Needed A 1P510 Driver Group 1 1. Install dowels (2) in control lever (I). 2. Put 8M8059 Bearing Mount on the outside diameter of the bushings and install them with tooling (A). 3-335

Privacy Statement
Press Release
Contact