ELEVATOR
INSTALL ELEVATOR
Tools Needed
A
1P510
Driver Group
1
1.
Fasten a hoist to the elevator and lower it in position.
2.
Slide link (1) on the elevator.
3.
Install pin (2) in the link. Install nut on back side of the
pin. Install the bolt that holds the pin in place.
4.
Do Steps 2 and 3 to install the other link.
5.
Use tooling (A) and a press to install bushing (3) in
bracket (4) with notch in alignment with grease fitting.
NOTE: Put the large chamfer to the inside on both bushings.
6.
Use tooling (A) and a press to install bushing (5) in
bracket (4).
4-148
