TM 5-3805-260-24
ELEVATOR LOWER SHAFT
DISASSEMBLE ELEVATOR LOWER
SHAFT
Tools Needed
A
8B7551
Bearing Puller Attachment
1
8B7548
Puller Assembly
1
8H684
Ratchet Box Wrench
1
8B7549
Leg
2
3H465
Plate
4
1B4207
Nut
2
8S6586
Screw
1
start by:
a)
remove elevator
I.
Put the elevator on the floor.
2.
Fasten a hoist to the elevator chain and lift the chain
off the roller.
3.
Remove nut and bolt (I) from the roller arm. Loosen
the other nut on the roller arm to permit roller to pivot
away from the chain. Remove hoist so chain is not
tight.
4.
Remove pin (lock) (2) from pin (3). Use hammer to
remove pin (3) from the chain.
5.Do Steps 2, 3 and 4 to disconnect chain on other side. After
both sides are disconnected lift flight (4) off the lower
rollers.
6.
Remove bolts (5) on the inside of hub (6). Remove the
washer in back of the bolts.
7.
Remove hub (6) with tooling (A).
4-150
