14.
Use two men to remove shaft (14) from the housing.
The weight of the shaft is 86 lb. (39 kg).
15.
Remove washers (shims) (17), lip type seal (15) and
bearing (16) from both ends of the housing. On the
inside diameter at the rear of bearing (I 16) is an O-ring
seal. Check the condition of the O-ring seal. If the seal
has damage, use new parts for replacement.
NOTE: Keep the washers (shims) together for reference during
installation.
ASSEMBLE ELEVATOR LOWER
SHAFT
Tools Needed
A
B
C
1P510
Driver Group
1
1P520
Driver Group
1
5P2706
Clamp Assembly
2
NOTE: Use 5P960 Multipurpose Type Grease on bolts and nuts.
1.
Fasten a hoist on the shaft housing. Install the bearing in
the shaft housing with tooling (A).
2.
Install O-ring seal (1) in the bearing.
3.
Use two men to install shaft (2) in the shaft housing
approximately in position shown.
4-152
