TM 5-3805-260-24
EJECTOR
REMOVE EJECTOR
start by:
a)
remove elevator
1.
To remove the rear cover assembly, see RE-
MOVE EJECTOR CYLINDER.
2.
Move the ejector forward for access to the rod
end of the ejector cylinder.
3.
Fasten a hoist to the lifting eye on the top of the
ejector.
4.
Put wood blocks between ejector cylinder (1) and
sliding floor cylinder (2).
5.
At the rod end of the ejector cylinder, remove
bolts (3) and cover (4) on both sides.
6.
Remove pin (5) to make a separation of the rod
end of the ejector cylinder from the ejector.
7.
Lift ejector for clearance and slide ejector
forward until rear rollers are out of their track.
8.
Turn the ejector and remove roller (6) from
each side of the ejector. Lift the roller straight
up for removal.
4-156
