TM 5-3800-205-23-2
AIR HOSE AND TUBES REPLACEMENT - CONTINUED
0012 00
AIR TUBE REMOVAL
NOTE
Perform following steps to replace eight air tubes on machine. Tubes are connected to hoses,
adapters, and elbows.
Tag tubes to aid in installation.
1.
At left-rear of scraper, disconnect tube (8) from elbow (9).
2.
Remove screw (10), washer (11), and clamp (12), as required, to allow removal of air tube (8) from machine.
3.
Disconnect other end of tube (8) from tube (13).
4.
Remove tube (8) from machine.
AIR TUBE INSTALLATION
NOTE
Remove old antiseizing tape and apply new antiseizing tape to male threads of all fittings before connections
are made.
1.
Position tube (8) on machine.
2.
Connect tube (8) to tube (13).
3.
Connect other end of tube (8) to elbow (9).
4.
If removed, install clamp (12) with washer (11) and screw (10).
8
10,11 12
9
13
8
390-1606
390-1607
WARNING
If machine is parked indoors, DO NOT run engine unless exhaust fumes are vented to the outside. Failure to
follow this warning may cause injury or death due to carbon monoxide poisoning.
5.
Start engine and fully charge air system (TM 5-3800-205-10-1).
6.
Check for air leaks.
7.
If removed, install toolbox and rear deck cover plate (WP 0017 00).
END OF WORK PACKAGE
0012 00-4
