TM 5-3800-205-23-2
BRAKE LINES REPLACEMENT - CONTINUED
0014 00
TUBE ASSEMBLIES REMOVAL
1.
Loosen nut (6) and disconnect tube assembly (7) from air/hydraulic brake cylinder (5).
2.
Loosen nut (4) from tee fitting (3) and remove tube assembly (7).
NOTE
Removal of left-side tube assembly, from tee fitting to brake caliper hose, is shown. Removal of right-side
tube assembly is the same, except for quantity of clamps that secure tube assembly to scraper frame.
3.
Loosen nut (2) and disconnect tube assembly (1) from tee fitting (3).
4.
Loosen nut (11) and disconnect tube assembly (1) from elbow (12).
5.
Remove three nuts (9), washers (10), and clamps (8) from studs (13). Remove tube assembly (1) from clamps.
2
1
3
4
5
13
6
8
12
7
9,10
11
TUBE ASSEMBLIES INSTALLATION
CAUTION
Always use two wrenches on fittings when installing brake lines. Failure to do so may damage fittings.
Care must be taken to ensure tube assembly nuts are not cross-threaded during installation.
NOTE
Installation of left-side tube assembly, from tee fitting to brake caliper hose, is shown. Installation of right-
side tube assembly is the same, except for quantity of clamps that secure tube assembly to scraper frame.
1.
Place tube assembly (1) inside three clamps (8) and position clamps on studs (13).
2.
Install three washers (10) and nuts (9) to secure tube assembly (1) and clamps (13) to scraper frame.
0014 00-2
