TM 5-3800-205-23-2
EJECTOR GUIDE ROLLER MAINTENANCE - CONTINUED
0038 00
ADJUSTMENT
NOTE
Ejector guide rollers are correctly adjusted if ejector does not contact sides of scraper bowl. Ejector guide
rollers should be in a position that prevents ejector from rising too far above the floor of scraper bowl.
1.
Loosen bolt (9).
2.
Move roller shaft (3) to a position that allows ejector
to pass over sides of scraper bowl.
3.
Tighten bolt (9).
4.
Repeat steps 1 through 3 for other ejector guide roller.
5.
Start engine (TM 5-3800-205-10-1).
6.
Move ejector forward and backward (TM 5-3800-205-
10-1). Check for drag between ejector and sides of
scraper bowl.
7.
Stop engine (TM 5-3800-205-10-1).
390-1733
3
9
8.
Repeat procedure if additional adjustment is neces-
sary.
END OF WORK PACKAGE
0038 00-4
