TM 5-3805-248-23-1
BLEEDING FOLLOW-UP CIRCUIT
THIS WORK PACKAGE COVERS
Service
INITIAL SETUP
Maintenance Level
Equipment Condition
Machine parked on level ground (TM 5-3805-248-
Unit
10)
Tools and Special Tools
Parking/emergency brake applied (TM 5-3805-248-
10)
Tool kit, general mechanic's (Item 113, WP 0338
Ejector moved forward (TM 5-3805-248-10)
Engine shut down (TM 5-3805-248-10)
Materials/Parts
Battery disconnect switch in OFF position (TM 5-
Oil, lubricating (Item 32, WP 0339 00)
3805-248-10)
Rag, wiping (Item 35, WP 0339 00)
Hydraulic pressure relieved (WP 0231 00)
SERVICE
WARNING
Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line or fitting
unless hydraulic system pressure has been relieved. Hydraulic system pressure can be over 2,500 psi
(17,237 kPa), even with engine and pump off. To relieve pressure, lower all hydraulic attachments to the
ground and shut down engine. Move control levers through all operating positions, then slowly loosen
hydraulic tank filler cap. After maintenance, tighten all connections before applying pressure. Escaping
hydraulic fluid under pressure can penetrate skin, causing injury or death.
Hydraulic oil is very slippery. Immediately wipe up any spills. Failure to follow this warning may cause
injury.
NOTE
Use a suitable container to capture draining hydraulic oil. Dispose of hydraulic oil IAW local policy and
ordinances. Ensure all spills are cleaned up.
1.
Start engine.
2.
Rotate steering wheel full right.
