TM 5-3805-260-24AIR COMPRESSORDISASSEMBLE AIRCOMPRESSORTools NeededAB1 P2321Puller Assembly1BH663Bearing Puller Attachment11 P457Plate1start by:a) remove air compressor1. Remove two bolts (2) and remove air compressor governor(I), the spacer and two gaskets from the aircompressor. NOTE: To disassemble governor (I)see REMOVE AIR COMPRESSOR GOVERNOR.2. Remove the cotter pin and nut (3) from the air compressor.3. Remove pulley (4) from the air compressor with tool (A).NOTE: Before the compressor is disassembled put identificationmarks on the crankcase, cylinder block, end covers, crankshaft,and cylinder head for correct installation and alignment atassembly.4. Remove cap nuts (5), the springs and dischargevalves.5. Remove bolts (6) and cylinder head (7).6. Remove gasket (8) and inlet valve springs (9) fromthe cylinder head.3-15
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business