TM 5-3800-205-23-2
FLOOR CYLINDER REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Installation
INITIAL SETUP
Maintenance Level
Materials/Parts - Continued
Direct Support
Rag, wiping (Item 31, WP 0047 00)
Tag, marker (Item 39, WP 0047 00)
Tools and Special Tools
Tool kit, general mechanic's (Item 33, WP 0048 00)
O-rings
Shop equipment, field automotive (Item 23, WP
References
TM 5-3800-205-23-1
Personnel Required
Equipment Condition
Two
Toolbox and rear deck cover removed (WP 0017
Materials/Parts
Cap set, protective (Item 5, WP 0047 00)
Quick disconnects at right side of draft arm discon-
nected (TM 5-3800-205-10-1)
Oil, hydraulic (Item 24 or 29, WP 0047 00)
WARNING
Do NOT disconnect or remove any hydraulic system line or fitting unless engine is shut down
and hydraulic system pressure has been relieved. Tighten all connections before applying pres-
sure. Escaping hydraulic fluid under pressure can penetrate the skin, causing serious injury.
At operating temperature hydraulic is hot. Allow hydraulic oil to cool before disconnecting
any hydraulics. Failure to do so could result in injury.
Hydraulic fluid is very slippery. Immediately wipe up any spills. Failure to follow this warning
may result in injury to personnel.
CAUTION
Cap all hoses and tubes to prevent fluid loss and contamination of oil system.
NOTE
Tag all lines, hoses, wires, and tubes to aid in installation.
Care must be taken to ensure that fluids are contained during performance of inspection, main-
tenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suit-
able containers before opening any compartment or disassembling any component containing
fluids.
Dispose of all fluids according to local regulations and mandates.
